v01.18 ------ - Spectra API v2.11 v01.17 ------ - Internal storage logic improvements - Bugfixes v01.16 ------ - Support for new Hardware ID - More efficient clearing of nodes (broadcast vs unicast) - Bugfixes v01.15 ------ - Default OLED_MODE set to AUTO_SLEEP - Fully fill the 400 pixels per port, even if this means blacking out some pixels on device - Bugfixes v01.14 ------ - Internal RDM protocol rework v01.13 ------ - Added support for new and more efficient smart E-Fuse v01.12 ------ - Added support for dynamic pixel count nodes (Lucenti PixlConverter) v01.11 ------ - Bugfix in current sensor calibration v01.10 ------ - Fans are now halted at startup v01.09 ------ - Added current sensor offset calibration through UI - Fix in OLED controller initialization v01.08 ------ - Sensor readings are now more efficient and asynchronous - HW ID support v01.07 ------ - Fixed bug where OLED display wasn't setup properly v01.06 ------ - Better FPS calculation and guards for input that is too fast - Fixed bug where identifying a controller did not take into account OLED sleep v01.05 ------ - Fixed bug that allowed more than 400 pixels per port - More efficient dealing with asserts - Optimized port power control (switching ON/OFF) v01.04 ------ - Fix for long cable lengths. Discovery and general data transfer now works as expected on short and long cable runs, up to 30m between controller and first bar - Fixed bug in FX engine start up - Added factory reset through initial button press v01.03 ------ - Added support for EMC2104 fan control v01.02 ------ - First release